SNK SC19-4 LED Cable

[diny1983]

Good evening everyone, I would like some advice from you. I can't figure out where I need to plug in the LED cable, the one that indicates the number of tokens inserted. Currently it's attached to the central "chip" but I can't figure out where the other outside should be attached. I'll send a picture to make myself understood. Thank you.

[Olisan]

I answer on Instagram too ^^

Need to be plugged on MVS motherboard. But connector is only on multi mvs board (2/4/6 slots, not on 1 slot only)

[diny1983]

I answer on Instagram too ^^

Need to be plugged on MVS motherboard. But connector is only on multi mvs board (2/4/6 slots, not on 1 slot only)

Thanks so much!

[BigPBigP]

I believe you can get an adapter board (recent construction not original mvs) that can allow the MV1B to add on a memory card slot and credit led lights as well. I have not used one and can't speak to their quality but I have been asked if I can supply them and made contact with the seller.

[diny1983]

I believe you can get an adapter board (recent construction not original mvs) that can allow the MV1B to add on a memory card slot and credit led lights as well. I have not used one and can't speak to their quality but I have been asked if I can supply them and made contact with the seller.

Why a memory card? What’s the MV1B? Thanks