Hey guys. I've tried reading the old posts on this topic but none of them are very clear (or perhaps I'm thick). Currently, I'm under the assumption that I must wire up a kick harness from the option connector located inside the control panel beside the 1P connector to the connector on the terminal board inside the cab here:
Is this correct? If so, How do I get button 6 from p1/p2 through to the Sega I/O board since button 6 supposedly (from the wiring diagrams) isn't passed through on the JAMMA connector?
As far as I remember the oblong connector under the CP is where the kick loom is connected to the buttons on the CP and you have a CPS2 kick harness and a connector that fits to the PCB on the side of the cash box.
Unfortunatley I haven't had or seen the correct loom.
Its the same if you have the JVS/JAMMA -001 loom - it only has buttons 1-4 wired up to the plugs under the CP.
Thanks for the response, penrhos. One more question and I think I'm good. How did you wire your kick buttons to the Sega JVS I/O? Did you modify the Jamma harness or solder directly to the Sega I/O for buttons 4/5 and use CN3 (I believe) for button 6? Only buttons 1-3 work for me in the JVS test screen and I'm using the -001 harness.
Prosolis wrote:Hey guys. I've tried reading the old posts on this topic but none of them are very clear (or perhaps I'm thick). Currently, I'm under the assumption that I must wire up a kick harness from the option connector located inside the control panel beside the 1P connector to the connector on the terminal board inside the cab here:
Is this correct? If so, How do I get button 6 from p1/p2 through to the Sega I/O board since button 6 supposedly (from the wiring diagrams) isn't passed through on the JAMMA connector?
Anyone know the pinout this? I'll continue to look and will post it if I find it.
CPS1/CPS2 you would want the standard kick loom for CPS2 but the other end would have an 8*1 molex wired for the Sega pinout - This would also work with the Capcom JVS-JAMMA adapter.
For a J-PAC you would wire the 8*1 molex to the screw terminals.
For a Sega V1 i/o you would take button 6 to CN3 the rest are available on the JAMMA connector (but your looms would have to have buttons 1-5 wired in).
I'm trying to locate the correct 8pin header/cable too. I'm looking at JST 8pin connectors, but there are so many different models, each with a combination of different sizes, pitch, distance between pins ,etc ,etc . Does anyone have a part number for this ? that would REALLY help.
Incase someone doesn't know the part number/name, I suggest just taking the board into your local electronics shop and asking. I often do this - "I need a replacement for.... this!" and they'll go off and find it for me
Currently, I'm under the assumption that I must wire up a kick harness from the option connector located inside the control panel beside the 1P connector to the connector on the terminal board inside the cab here:
