pony18 back sticker reproduction
Forum rules
ArcadeOtaku forum introduction & rules
ArcadeOtaku forum introduction & rules
pony18 back sticker reproduction
Could somebody do a good frontal pic of his back sticker? I would like to reproduce it. Thanks
Arcade is nice when it's done well
-
- Posts: 16
- Joined: May 24th, 2017, 7:07 pm
- Location: San Francisco
- eBay: masamuneGTO
- Contact:
Re: pony18 back sticker reproduction
Which back sticker?
-
- Posts: 16
- Joined: May 24th, 2017, 7:07 pm
- Location: San Francisco
- eBay: masamuneGTO
- Contact:
Re: pony18 back sticker reproduction
Ahh, gotcha. You want a higher resolution image of the serial number plate (it's actually a thin piece of medal with adhesive, FYI). I can take a photo of the one on mine this evening.
Re: pony18 back sticker reproduction
Thanks a lot!! Please take a very frontal pic like this there will be no symetrical issue.
Arcade is nice when it's done well
Re: pony18 back sticker reproduction
You can correct the distortion from the camera with software. If someone sends me the raw image I can make it rectilinear, perfect for vectoring.
Re: pony18 back sticker reproduction
A scan would be the best. There is a guy called battlesmurtf who had one, he told me he will reproduce some but still this no news.
Arcade is nice when it's done well
Re: pony18 back sticker reproduction
Of course, but not sure how many want to pry theirs off from the cab. If you do it incorrectly you will inevitably dent it.
- cools
- Armed Police Buttrider
- Posts: 12524
- Joined: August 17th, 2008, 4:49 pm
- Location: Wales, United Kingdom
- eBay: hordarian
- Initials: CLS
Re: pony18 back sticker reproduction
No-one on the planet is getting one of these off without bending it in some way, short of managing to dissolve the glue under it. The metal is extremely malleable. Haven't figured out how to flatten the one on my Pony 25 (which is identical to the one shown), but then I don't particularly care - I'd sell it if it was worth anything.

Re: pony18 back sticker reproduction
Would you like to sell it?cools wrote: ↑August 9th, 2018, 2:55 MPNo-one on the planet is getting one of these off without bending it in some way, short of managing to dissolve the glue under it. The metal is extremely malleable. Haven't figured out how to flatten the one on my Pony 25 (which is identical to the one shown), but then I don't particularly care - I'd sell it if it was worth anything.
Arcade is nice when it's done well