Help wiring a Point Blank PCB

[nem]

@Neilnc30, I can assure you, nothing that's made in Japan ever comes with a Molex connector. It's a pet peeve of mine, sorry.

I don't have a board, but there's a pic of it in this thread:

viewtopic.php?p=463946#p463946

Looks like Mini-Universal Mate-n-Lok to me:

https://www.te.com/global-en/products/c ... ories.html

[Neilnc30]

Thanks so much for your post on here, it’s invaluable to wiring up my point blank! I have the connectors now and it’s almost ready to go, however I’m struggling to find a c-sync to wire the brown from J4 to, can you tell me where it is? I can find a v-sync. Would this suffice? Thanks, Neil

[Neilnc30]

I just connected all, following advices and diagramas, but I have a doubt looking this diagram:


Do I have to connect +24v from power supply to hole #1 on the J4 J2 connector?

If this Possition PCB gets power from J1 connector, it seems extrange to me that J4 J2 connector was also reciving +24v directly from the power supply...

Do I need to supply 24v also to this position to get working solenoids?

[nem]

Do I need to supply 24v also to this position to get working solenoids?

I'm pretty sure you will have continuity between J1 pin 1 and J2 pin 1 and 2. You can check this with a multimeter. However, there's no harm in adding it separately to J2 as well.

Did you figure out C_SYNC yet?

[Neilnc30]

No continuity between the pins so added another +24v to j2 socket 1 and now I can get recoil on my gun 2, the thermal fuse has blown in gun 1 so have ordered a replacement. The trouble is in the engineer mode I can’t keep the recoil as on, it instantly switches back to off in the menu. but the recoil itself works in test mode

C-sync issue sorted