Weiya C3129A on Sanwa 29E31S tube

[purplec]

Hi

So I got Weiya chassis of an op for free and it looks clean but I don't know if it's working. I have a Sanwa tube and it fits nicely and everything looks connected with the exception of the yoke wires.

The tube has the standard yoke wires but I'm not certain which is h and v so I can place them on the right way on the Weiya chassis. If anyone could tell me what the colours are for the v yoke and the h yoke on the Sanwa tube it would be great.

I notice that the Sanwa chassis was a lot bigger and the Weiya is quite smaller would it be ok to put the chassis on a piece of mdf behind the screen to test?


Any help is appreciated

[RMRM]

Red / Blue - Horizontal
Brown / White - Vertical.

You CAN'T mess vertical with horizontal or you might burn the chassis

EDIT - read this document, good info here - http://www.crtsolutions.com/CRTSafety.pdf

[purplec]

Thanks dude that's why asked

[purplec]

Here's a pic of the yoke wires connected



http://i306.photobucket.com/albums/nn26 ... deaa0u.jpg

Yellow is attached to white
Green is attached to brown

I will power it up over the weekend does any one think I have it connected wrong

[RMRM]

I'm afraid that you have white and brown wrong, but you can test like that. If the imagem is fliped, just switch those two and you are good to go.

[purplec]

Ok now I know why it was free.

It doesn't work, chassis says its 220 or 110.

I wired up to 220 and turned it on, I could hear it come on but could smell plastic.

I turned it off and I could some smoke from the lopt on the chassis