can anybody confirm that the black 1 pin plug coming of the tube ground braided wire, plugs into the single pin numbered cn508 on the chassis ??? the cable is too short to reach the pin when rotated to vertical. we are about to extend the cable in order to lengthen it.
cheers.
john bud
egret ms9 monitor.
- johnbud
- Please Continue...
- Posts: 236
- Joined: February 24th, 2010, 11:00 am
- Location: north lanarkshire
- Initials: ELF
- johnbud
- Please Continue...
- Posts: 236
- Joined: February 24th, 2010, 11:00 am
- Location: north lanarkshire
- Initials: ELF
Re: egret ms9 monitor.
or does it plug into cn 031 on the neck card ???
- johnbud
- Please Continue...
- Posts: 236
- Joined: February 24th, 2010, 11:00 am
- Location: north lanarkshire
- Initials: ELF
Re: egret ms9 monitor.
thanks bud, it made sense it was too short to reach the chassis. hope fully in the next couple of hours this egret is sorted.
cheers.
john bud
cheers.
john bud
- johnbud
- Please Continue...
- Posts: 236
- Joined: February 24th, 2010, 11:00 am
- Location: north lanarkshire
- Initials: ELF
Re: egret ms9 monitor.
job done shooter loaded, rock and roll. first its been fired up in yonks, feels good to be out there killing again