Egret 3 monitor swap Toshiba PF

[Ariya]

Hi there, i believe i can swap my other e3 monitor (lg-philip) with a Toshiba PF, worrying about the wiring though..need to make a new power cord, and run everything through VGA (mame) what about playing 15k PCB? Tosh has a separate RGB connector, right beside the vga (main chassis), how can i output the 15k sognial? I think i have to bridge the vga pcb from jamma to Toshiba chassis, is that right? Someone talking about a synk connector hidden in the floor... can't find it!

Would someone be able to provide a picture? Thank you

[sven666]

I have the same problem right now, my tosh pd1843 does not like the jamma 15khz signal, havent found a solution yet..

[Ariya]

You mean you're not be able to play 15k pcb? chassis is well connected i believe, i plugged in a pandora with no luck..no signal!

[sven666]

I cant get it to sync, it does have picture tho

[nakajima]

Hi, tomorrow I can send a few pictures. I have a Atomiswave SD with Tosh PF with no problems with 15 or 31KHz. I don’t need to touch anything, the chassis is auto.

Sorry for my bad English...

[sven666]

well, im using the jamma>VGA converter thats standard in the AWSD cabs, the inputs/outputs seem to match up with the inputs on the chassis.

my tosh chassis has two inputs, P201, P202.
in 201 i get no picture at all
in 202 i get picture but it wont synch

there is a 3stage switch on the chassis, not sure what this does, doesnt seem to affect the picture either way at this point?

[cools]

viewtopic.php?p=451296#p451296

[sven666]

20210319_123849.jpg

Dude that did the trick!

(I should really get a different test-pcb btw )

[sven666]

And to be clear its this little rascal here.

20210319_125951.jpg

[nem]

That's certainly odd! Would be interesting to know where the wires terminate to.

[neokoen]

That's certainly odd! Would be interesting to know where the wires terminate to.

Plugging in the D connector will tie the V-sync (output on the DB15 connector) to the C-sync on the built-in VGA/DB15 adapter board in the cab.

[Ariya]

And to be clear its this little rascal here.
20210319_125951.jpg

Did you sorted out? Would you like to explain? Thank you

[nakajima]

sorry everyone, i'm late Like Sven, it works perfectly for me with the D1 and D2 connectors disconnected

[sven666]

And to be clear its this little rascal here.
20210319_125951.jpg

Did you sorted out? Would you like to explain? Thank you

Yup works fine now, the vga needs to be connected to port 202 on the chassis (not sure why 201 doesnt work?).
And disconnect the D connectors in the bottom and it should work fine

[Ariya]

Thank you