Page 1 of 1
Naomi nanao yoke
Posted: September 6th, 2020, 7:30 am
by zumbito
I have a NAomi whith a Nanao monitor (not usre if 2932 or 2934), thing is the image looks all folded over, like half vertical colapse. I took it to the technician, and he repaired the monitor, but when I took it back it still had the same issue. I took the chasis and tube this time and he said it was the yoke. So I tried to source one without luck. Does anyone know it the one of 2931 will work? OR does anyone has one for sale?
Thanks!
Re: Naomi nanao yoke
Posted: September 6th, 2020, 10:33 am
by nem
2930 / 31 / 32 / 33 / 34 are all 0.200mH, so at least you won't blow anything up. With some yokes you need to replace the heater resistor with a different one (the picture will be dim). Try it and see what it looks like.
Re: Naomi nanao yoke
Posted: September 6th, 2020, 10:38 am
by grantspain
heater resistor is only if you swap tube and is of different manufacturer
Re: Naomi nanao yoke
Posted: September 6th, 2020, 11:29 am
by PrincessPrinPrin
zumbito wrote: ↑September 6th, 2020, 7:30 am
I took it to the technician, and he repaired the monitor, but when I took it back it still had the same issue. I took the chasis and tube this time and he said it was the yoke.
If it was the yoke what did he repair the first time around?
Re: Naomi nanao yoke
Posted: September 6th, 2020, 1:36 pm
by nem
grantspain wrote: ↑September 6th, 2020, 10:38 amheater resistor is only if you swap tube and is of different manufacturer
Well yeah, now that you say it, that does make more sense
However, different manufacturer? I had to do this on a chassis sometime ago, when I swapped a 2933 chassis on a 2930 monitor. Both tubes were Tosh. Didn't think to check the tube model number though, because both were seemingly the same.
Re: Naomi nanao yoke
Posted: September 14th, 2020, 9:22 am
by zumbito
PrincessPrinPrin wrote: ↑September 6th, 2020, 11:29 am
zumbito wrote: ↑September 6th, 2020, 7:30 am
I took it to the technician, and he repaired the monitor, but when I took it back it still had the same issue. I took the chasis and tube this time and he said it was the yoke.
If it was the yoke what did he repair the first time around?
Exactly... He said he changed some stuff, what can I say... Good thing is I tried it the other day in a friend's Naoi and it worked. At least that's something. I will use a 2931 then, I have one lying around.
Re: Naomi nanao yoke
Posted: September 14th, 2020, 9:48 am
by grantspain
i have seen bad vertical winding take out vertical ic before
Re: Naomi nanao yoke
Posted: September 14th, 2020, 9:52 am
by zumbito
I trust the guy, there is always the doubt, but he normally repairs things, or if he can't he doesnt charge anything.