Hi guys,
I'd like to know if this shema is correct. Also, should I use 18awg, maybe 22awg is too thin?
About the connector: what's happend if, when I turn-on the cab/monitor, the connectors are disconnect like in this shema? I know it do not have any sens to make this wiring and leave it disconnected, but I'd like to know what kind of effect it will occurs on resolution, also maybe it can do a short-circuit, or totaly safe?
Thanks!!
Wide-Narrow jumper on MS8-18 series
-
erzane
- Not Made In Japan
- Posts: 824
- Joined: August 23rd, 2008, 12:52 pm
- Location: CH
- eBay: Gab79
Wide-Narrow jumper on MS8-18 series
You do not have the required permissions to view the files attached to this post.
Arcade's nice when done well
-
nem
- Needs a custom rank
- Posts: 2776
- Joined: August 17th, 2008, 6:59 pm
- Location: Finland
Re: Wide-Narrow jumper on MS8-18 series
The switch will have to be connected at all times. It has to be a closed circuit.
-
erzane
- Not Made In Japan
- Posts: 824
- Joined: August 23rd, 2008, 12:52 pm
- Location: CH
- eBay: Gab79
Re: Wide-Narrow jumper on MS8-18 series
Okay, Thanks!!
Is it the same rule for some geometry pots deported?
You do not have the required permissions to view the files attached to this post.
Arcade's nice when done well
-
nem
- Needs a custom rank
- Posts: 2776
- Joined: August 17th, 2008, 6:59 pm
- Location: Finland
Re: Wide-Narrow jumper on MS8-18 series
You absolutely have to have the pots connected, yes.
-
erzane
- Not Made In Japan
- Posts: 824
- Joined: August 23rd, 2008, 12:52 pm
- Location: CH
- eBay: Gab79
