Anyone have the part number for a connector that will fit the ground/dag pin on a Blast City neck board?
The connector on my Windy 2 is too small to fit the thicker ground pin on the MS2933 neck board I'm trying to use.
Nanao MS2930/MS2931/MS2933 Neck Board Dag Connector
-
- Posts: 99
- Joined: September 29th, 2013, 5:09 pm
- Location:
- PunkicCyborg
- Posts: 49
- Joined: May 22nd, 2013, 5:29 pm
- Location: Tampa FL
- eBay: evan_labit
Re: Nanao MS2930/MS2931/MS2933 Neck Board Dag Connector
I just cut the plastic back a bit to get to the pin inside and spread it open a little bit with a screw driver so it fits then put some shrink tube over the pin. Same for Degauss