Nanao MS2930/MS2931/MS2933 Neck Board Dag Connector

For monitor related issues
Post Reply
kuze
Posts: 89
Joined: September 29th, 2013, 5:09 pm
Location:

Nanao MS2930/MS2931/MS2933 Neck Board Dag Connector

Post by kuze » May 3rd, 2019, 1:06 am

Anyone have the part number for a connector that will fit the ground/dag pin on a Blast City neck board?

The connector on my Windy 2 is too small to fit the thicker ground pin on the MS2933 neck board I'm trying to use. :(

User avatar
PunkicCyborg
Posts: 38
Joined: May 22nd, 2013, 5:29 pm
Location: Tampa FL
eBay: evan_labit

Re: Nanao MS2930/MS2931/MS2933 Neck Board Dag Connector

Post by PunkicCyborg » May 6th, 2019, 1:30 am

I just cut the plastic back a bit to get to the pin inside and spread it open a little bit with a screw driver so it fits then put some shrink tube over the pin. Same for Degauss

Post Reply