Hi, I've purchased a Blast City a while ago.
However, it shows a horrible picture ever since regarding the colours and the image in general. A few days ago I've noticed that the MS2930 Toshiba tube has a chassis from a MS2932 connected...
Is there any possibility to find a correct replacement chassis? Is it dangerous for the tube to use the current setup?
Nanao MS2930 abomination with 2932 chassis
- Benimaru
- Posts: 51
- Joined: October 12th, 2018, 8:23 pm
- Location: Germany
- eBay: extension55
- Initials: PDG
- grantspain
- Tech Head
- Posts: 4823
- Joined: August 17th, 2008, 4:23 pm
- Location: down south
Re: Nanao MS2930 abomination with 2932 chassis
ms2932 is compatible with ms2930 tube/yoke
maybe you have a weak gun. photo of a colour graduation test should show any issues
maybe you have a weak gun. photo of a colour graduation test should show any issues
- Benimaru
- Posts: 51
- Joined: October 12th, 2018, 8:23 pm
- Location: Germany
- eBay: extension55
- Initials: PDG
Re: Nanao MS2930 abomination with 2932 chassis
It's looking like that in the corners, the picture is literally "falling off".
- grantspain
- Tech Head
- Posts: 4823
- Joined: August 17th, 2008, 4:23 pm
- Location: down south
Re: Nanao MS2930 abomination with 2932 chassis
convergence is out
-
- Posts: 110
- Joined: August 21st, 2008, 7:49 am
- Location: Germany
Re: Nanao MS2930 abomination with 2932 chassis
with a small magnet well positioned on the correct Position on the back of the tube should show improvement or fix this....
This little convergence Problem comes from the Tube itself and not from the Chassis.
This little convergence Problem comes from the Tube itself and not from the Chassis.
- Benimaru
- Posts: 51
- Joined: October 12th, 2018, 8:23 pm
- Location: Germany
- eBay: extension55
- Initials: PDG
Re: Nanao MS2930 abomination with 2932 chassis
Thanks a lot, will try with those magnetic strips.