So I am helping a friend with their new cab. Just bought it off a guy, the wiring in the cab was all cut up, but he showed the monitor working on his test bench.
Now that it's at home and we're wiring it up JAMMA from scratch, RGB was easy to figure out.
But I'm left with two questions:
Where do the two Degauss lines go? Just to each side of the button and you're good?
What about Video Ground, and sync?
I see no documentation in the wiki.
Nanao MS7-18 - wiring it up
- rewrite
- Posts: 203
- Joined: April 30th, 2014, 4:11 am
- Location: California, USA
- eBay: quin-leyd
- Initials: ATP
- PrincessPrinPrin
- Posts: 577
- Joined: April 7th, 2011, 4:00 pm
- Location: Pordenone, Italy
- eBay: *mkl*
- Initials: MKL
Re: Nanao MS7-18 - wiring it up
Video ground and sync are next to the RGB pins on the same header and surely screen printed. I don't think there is an option for a degauss button, just the header for the coil.
- Sp33dFr34k
- Posts: 277
- Joined: December 3rd, 2011, 12:27 pm
- Location: The Netherlands
- eBay: 3d_collector
Re: Nanao MS7-18 - wiring it up
Just had a look at your usernames and LOL'd
- FrancoB
- J+ member of the year finalist!
- Posts: 4758
- Joined: June 8th, 2009, 10:42 pm
- Location: Oxfordshire
- eBay: francosquashking
- Initials: FRN
Re: Nanao MS7-18 - wiring it up
Gobble gobble
- rewrite
- Posts: 203
- Joined: April 30th, 2014, 4:11 am
- Location: California, USA
- eBay: quin-leyd
- Initials: ATP
Re: Nanao MS7-18 - wiring it up
Oyyyy, you guys...
Sync and video ground were determined, they're wired up to the JAMMA harness, and that's the result:
https://forum.arcadeotaku.com/viewtopic.php?f=4&t=37547
Sync and video ground were determined, they're wired up to the JAMMA harness, and that's the result:
https://forum.arcadeotaku.com/viewtopic.php?f=4&t=37547