MS9 convergence woes
Posted: February 12th, 2018, 6:43 am
So my monitor started falling out of convergence after a rotation in the top left corner and a tad in the top right corner. It had minor convergence issues on a whole in the past but i didnt bother with it.
So now that its to the point its pretty noticeable i decided to learn how to do convergence with the static rings on the neck. MAN is this driving my OCD bonkers. I can get it dialed in almost prefect but a few spots always show up after looking again. (its like your eyes start to play tricks on you) I fiddle and throw it all off again and start over. Mainly the red and blue.
As far as the corners go I made some convergence strips which work great but i adjust or add/remove those after redialing in the center.
Im guessing its nearly impossible to get perfect convergence. I used to think it was perfect but now i guess that i know what im looking for i cant unsee flaws
I can add pictures soon, calling it a night after spending hours on that thing
Any tips from anyone for a first timer
So now that its to the point its pretty noticeable i decided to learn how to do convergence with the static rings on the neck. MAN is this driving my OCD bonkers. I can get it dialed in almost prefect but a few spots always show up after looking again. (its like your eyes start to play tricks on you) I fiddle and throw it all off again and start over. Mainly the red and blue.
As far as the corners go I made some convergence strips which work great but i adjust or add/remove those after redialing in the center.
Im guessing its nearly impossible to get perfect convergence. I used to think it was perfect but now i guess that i know what im looking for i cant unsee flaws
I can add pictures soon, calling it a night after spending hours on that thing
Any tips from anyone for a first timer