Hi all.
I've got a Nanao MS8 monitor in my AC, and the remoteboard for these are slightly different, from the ones with MS9.
The small plastic-"screws" for adjusting feels very tight, and sometimes it can be hard to do the adjustments with bare hands, and I don't want to fiddle with screwdrivers everytime.
My question is - would it make any harm, to try and drip a little oil (dielectric grease?) on the screwterminals? Or do you have any other suggestions?
MS8 Remote Board
- KennethHansen
- Please Continue...
- Posts: 15
- Joined: February 7th, 2016, 8:19 pm
- Location: Denmark
- Initials: KMH
- DaveyD
- Posts: 344
- Joined: December 9th, 2014, 7:14 am
- Location: Grimsby, UK
- eBay: Dr_Daph
- Initials: DPD
Re: MS8 Remote Board
If you are ok with soldering you could fit some new potentiometers