Please do!outrun2 wrote:I would have thought the pin numbers would have been consistent between the two PCBs but I can check tomorrow for you if you like.
I have already lost a ton of time testing every combination, and then i noticed the ground was making contact with something else, which made all the tests pointless.
Just tell me what the pin sequence is for each end of the cable, and i can finally sort this mess out.
At this time the answer, in my case is:
- I damaged something
- A resistor on the remote board is faulty.
Even if something is not working on mine, at least i can rest assured i have the pinout right.