egret ms9 monitor.

For monitor related issues
Post Reply
User avatar
johnbud
Posts: 234
Joined: February 24th, 2010, 11:00 am
Location: north lanarkshire
Initials: ELF

egret ms9 monitor.

Post by johnbud » September 26th, 2011, 12:14 pm

can anybody confirm that the black 1 pin plug coming of the tube ground braided wire, plugs into the single pin numbered cn508 on the chassis ??? the cable is too short to reach the pin when rotated to vertical. we are about to extend the cable in order to lengthen it.

cheers.

john bud

User avatar
johnbud
Posts: 234
Joined: February 24th, 2010, 11:00 am
Location: north lanarkshire
Initials: ELF

Re: egret ms9 monitor.

Post by johnbud » September 26th, 2011, 12:18 pm

or does it plug into cn 031 on the neck card ???

User avatar
kernow
:problem: child
Posts: 14806
Joined: August 17th, 2008, 2:01 pm
Location: Devon
Initials: KRN
Contact:

Re: egret ms9 monitor.

Post by kernow » September 26th, 2011, 12:35 pm

yes it does, plugs into the neck card.
David... The wind blows... The wind blows... Bits of your... life awayee

User avatar
johnbud
Posts: 234
Joined: February 24th, 2010, 11:00 am
Location: north lanarkshire
Initials: ELF

Re: egret ms9 monitor.

Post by johnbud » September 26th, 2011, 12:38 pm

thanks bud, it made sense it was too short to reach the chassis. hope fully in the next couple of hours this egret is sorted.

cheers.

john bud

User avatar
johnbud
Posts: 234
Joined: February 24th, 2010, 11:00 am
Location: north lanarkshire
Initials: ELF

Re: egret ms9 monitor.

Post by johnbud » September 26th, 2011, 4:14 pm

job done :thumbup: shooter loaded, rock and roll. first its been fired up in yonks, feels good to be out there killing again :lol:

Post Reply