Sanwa PW-1545
- radiantsvgun
- Please Continue...
- Posts: 264
- Joined: January 13th, 2009, 9:20 pm
- Location: Georgia, USA
- eBay: Radiantsvgun
- Initials: RIC
Sanwa PW-1545
Anyone have any info on this chassis- I have it on a mini cute tube but information is sparse. I did some trouble shooting as far as caps and adjusting B+, but I can’t find any other information on it. It had some connectors spliced so I’m wondering if it’s for this tube at all. The H size pot is broken, and it’s one of those weird ferrite looking ones but it has an actual handle. Anyone have a manual, schematic or any repair info on it?
- PrincessPrinPrin
- Posts: 577
- Joined: April 7th, 2011, 4:00 pm
- Location: Pordenone, Italy
- eBay: *mkl*
- Initials: MKL
Re: Sanwa PW-1545
Very similar to the PM1723. Old, obsolete design without diode modulator so no h size adjustment with pot, only with coil.
You do not have the required permissions to view the files attached to this post.
- radiantsvgun
- Please Continue...
- Posts: 264
- Joined: January 13th, 2009, 9:20 pm
- Location: Georgia, USA
- eBay: Radiantsvgun
- Initials: RIC
Re: Sanwa PW-1545
Oh wow, thank you so much!PrincessPrinPrin wrote: ↑April 24th, 2022, 1:55 pm Very similar to the PM1723. Old, obsolete design without diode modulator so no h size adjustment with pot, only with coil.
Sanwa PW1545.jpg
- radiantsvgun
- Please Continue...
- Posts: 264
- Joined: January 13th, 2009, 9:20 pm
- Location: Georgia, USA
- eBay: Radiantsvgun
- Initials: RIC
Re: Sanwa PW-1545
I wanted to follow up - repair of this consisted of a full recap, including the filters, the caps were still factory.
Bad solder all around, full reflow, and 4 of the adjustment pots needed to replaced.
Bad solder all around, full reflow, and 4 of the adjustment pots needed to replaced.