This is the info that I need for the 'Japanese' marquee holder (red lines A - J):
And this for the 'Europese' marquee holder:
Please notice that A should be measured between the green guide lines. The measurements D through H are most important and should be accurate. And the measurements involving the holes should be measured from the center of the holes. And what is the diameter of the bottom holes (I don't know if the original marquee holder has holes behind the top metal clips, but I will use M4 bolts instead of the clips). If possible I would like measurements in mm's.

I will make the marquee holders with the beveled edge, like the original marquee holders have too.
Thx in advance.