Minicute art in the wiki

[zumbito]

I;m trying to silk print the mini cute art in the wiki, but apparently I need vector files. The art in the wiki are pdfs. Does anyone know who uploaded them or has the vector files? Thanks!

[cools]

The speaker part is a bitmap PDF, the other two are vector PDFs

[zumbito]

The speaker part is a bitmap PDF, the other two are vector PDFs

Thanks, I'm not very handy with AI, I was just told that I needed vector files to silkprint so I just rasterised it and cut the holes, hope it turns out OK. Wiht bitmap, they told me it couldn't be done.

[cools]

Raster = bitmap.

[zumbito]

Raster = bitmap.

Ok, then I vectorised it...

[zumbito]

Well I finally got my Cute arts printed, not bad but I have a problem.
The speaker surrounding didn't have the holes in the wiki, so I decided to draw them cause I had no idea how to do perfect circles once printed. Well, I missed the size, luckily they are a tad small (too big would have been complete f***k up), so I am back to square one. How do I cut perfect circles into the sticker. Any ideas? I can't use the cab as a template cause it would ruin the paint...
Here is the art, silk printed:


This are the holes that need to be widen a little bit, like a cm.

[orio1]

[cools]

I'd find something the same size to use as a template, or get some metal water/laser cut.

[PrincessPrinPrin]

I had no idea how to do perfect circles once printed.

https://www.amazon.co.uk/Rolson-62949-C ... B001MJ0BJI