Hi at all.
I've a lovely NVC (with 2x Nanao ms-2930s, manual tri sync) where I've connected my Naomi at 15khz, 'cause I've not found where to connect the VGA cable in the cabinet.
In fact, I'd like to connect my Naomi to VGA cable for the 31khz, but I don't know where the VGA cable has to be connected for this purpose.
If I connect my Naomi to one monitor, the monitor on the other side of the cab remain spares... With no signal
The Naomi has one VGA output, but the monitors are 2 in the New Versus City, both with personal VGA input....
How can I make the VGA connection for both monitors, taking the VGA signal from Naomi?!?
Has the NVC a PCB inside that splits the signal?
The monitors are 2 normal Nanao that you can see in the normal 1-monitor candies.
Thx.
Antonio
Sega New Versus City - VGA cable...where?!?
-
tonysnk
- Posts: 4
- Joined: March 7th, 2014, 10:54 am
- Location:
-
tonysnk
- Posts: 4
- Joined: March 7th, 2014, 10:54 am
- Location:
Re: Sega New Versus City - VGA cable...where?!?
To connect my Naomi to the NVC I use a jamma-to-jvs converter....
If I connect the output VGA of the Naomi to the VGA input of the converter, can I have the signal splitted in both monitors at 31khz via jamma harness, without connecting directly the VGA cable to every monitor?!?
If I connect the output VGA of the Naomi to the VGA input of the converter, can I have the signal splitted in both monitors at 31khz via jamma harness, without connecting directly the VGA cable to every monitor?!?