Need Help on AMP Up connector
Posted: November 28th, 2016, 8:16 pm
Hey guys,
I tried to make an CPS2 - Kick harness for my CPS2 on my own. For sure without any special tool for crimping.
Due to that I am facing now a problem with a lost cable on a pin on the AMP UP connector. The pin is snapped into the connector now without any cable on it.
Is there any possibility to disengage or push out the pin out of the connector again without special tool?
Please find enclosed a picture of the harness.
https://www.dropbox.com/s/x2vpshe1qxgqvlw/cps.png?dl=0
I tried to make an CPS2 - Kick harness for my CPS2 on my own. For sure without any special tool for crimping.
Due to that I am facing now a problem with a lost cable on a pin on the AMP UP connector. The pin is snapped into the connector now without any cable on it.
Is there any possibility to disengage or push out the pin out of the connector again without special tool?
Please find enclosed a picture of the harness.
https://www.dropbox.com/s/x2vpshe1qxgqvlw/cps.png?dl=0