A tool for every job

Arcade cabinet hardware and accessories
Forum rules
ArcadeOtaku forum introduction & rules
User avatar
megalomaniac
Posts: 83
Joined: October 21st, 2009, 12:28 pm
Location: UK
eBay: megalomaniac_uk
Contact:

Re: A tool for every job

Post by megalomaniac » December 17th, 2016, 1:57 pm

Paulie, Soldering talk: I'm looking to replace my cheapo Antex. Any particular reason you went Metcal over Hakko? What model(s) of Hakko were you looking at? Would you make the same choice now?

Thanks :D
"If there's anything more important than my ego around, I want it caught and shot now!"
Twitter | Blog

User avatar
Hellfromabove
Posts: 369
Joined: January 8th, 2009, 11:19 am
Location: SoCal

Re: A tool for every job

Post by Hellfromabove » July 31st, 2017, 12:32 am

Paulie wrote:/snip
Paulie, if you ever come back on to AO, is it possible you can update the pics by uploading them to a new host? Looks like you were using PB before and since they now have a cap on picture bandwidth, the images are no longer visible.

User avatar
Paulie
Opens wallet, moths fly out
Posts: 2935
Joined: September 28th, 2011, 5:43 pm
Location: Batley, West Yorks
eBay: retro-paulie
Initials: PSG

Re: A tool for every job

Post by Paulie » October 2nd, 2017, 9:09 pm

Hellfromabove wrote:
Paulie wrote:/snip
Paulie, if you ever come back on to AO, is it possible you can update the pics by uploading them to a new host? Looks like you were using PB before and since they now have a cap on picture bandwidth, the images are no longer visible.
I'll have a look at it and see if I can move them :)

User avatar
Flinnster
Posts: 318
Joined: September 19th, 2016, 12:06 am
Location: Surrey
eBay: flinnster
Initials: KID

Re: A tool for every job

Post by Flinnster » October 2nd, 2017, 10:29 pm

\o/ Welcome back Paulie! :D
WTD: Rainbow Islands, Rolling Thunder, Naomi castor wheel, coin mech metal clip for Dino King Door

geldra
Posts: 167
Joined: December 18th, 2008, 1:09 pm
Location: South Shields, UK.

Re: A tool for every job

Post by geldra » December 19th, 2018, 2:15 pm

Does anyone have a recommendation for a good quality drill bit set? I have some bolts on a NAC that need drilling out unfortunately and the bits I have are struggling to do the job.
God I hope this Xenepp made Mame board is good.

Post Reply