My Egret2 has a problem I think the PSU working correct.
Sound is fine put the picuture do not working correct only lines and glitches.
Who can repair this CPU or can help me to clear this problem?
I can do some pictures if needed.
Thanks,
Chris
Egret 2 working not correct vertical lines (help needed)
-
- Posts: 31
- Joined: July 20th, 2011, 8:17 pm
- Location: Europe
- eBay: neogeomeister
Egret 2 working not correct vertical lines (help needed)
Last edited by neogeomeister on June 5th, 2013, 6:41 pm, edited 3 times in total.
-
- Posts: 31
- Joined: July 20th, 2011, 8:17 pm
- Location: Europe
- eBay: neogeomeister
Re: Egret 2 PSU working not correct!? (help needed)
Connections to the power supply is correct I will send tomorrow some pictures.
-
- Posts: 31
- Joined: July 20th, 2011, 8:17 pm
- Location: Europe
- eBay: neogeomeister
- yosai
- Windy City
- Posts: 4061
- Joined: August 17th, 2008, 5:00 pm
- Location: London
- eBay: yosai
Re: Egret 2 working not correct vertical lines (help needed)
all pcbs produce the same type of image? Check that the monitor is not in 24k.
- emphatic
- Breastfeeds when required
- Posts: 5874
- Joined: April 7th, 2009, 4:14 pm
- Location: Alingsås, Sweden
- eBay: jorgen_sjolander
- Initials: JOR
Re: Egret 2 working not correct vertical lines (help needed)
Either that (24khz) or the horizontal hold pot for 15khz (VR550) needs a fine tweak.
(These are under the front of the monitor tube, "pop the hood" then use a small (preferably plastic) screwdriver to adjust it).
(These are under the front of the monitor tube, "pop the hood" then use a small (preferably plastic) screwdriver to adjust it).
My games: http://www.emphatic.se
-
- Posts: 31
- Joined: July 20th, 2011, 8:17 pm
- Location: Europe
- eBay: neogeomeister
Re: Egret 2 working not correct vertical lines (help needed)
Thanks to all my picture works again!
It was the 15khz and the 24khw port the needs only an adjust.
It was the 15khz and the 24khw port the needs only an adjust.
- wonderbanana
- You can't polish a turd, but I can
- Posts: 1041
- Joined: January 16th, 2011, 2:57 pm
- Location: Herts, UK
Re: Egret 2 working not correct vertical lines (help needed)
neogeomeister wrote:Thanks to all my picture works again!
It was the 15khz and the 24khw port the needs only an adjust.
markedkiller78 wrote:that's probably my best contribution to the forum to date "I am pluralising fanny"