Hope I can explain this one ok as there are a few variables
Im running a sega naomi set up in a standard jamma cab via a capcom i/o, the naomi is running one of Joerg's multi carts with the correct bios. The naomi boots up, fan runs, but no picture is displayed and ive trued it on a couple of cabs no to the same result. Usually Joerg is easy to reach and quick to respond, but I cant reach him this time around...
The other thing is that when putting a pcb back in the cab, its notably thrown the picture out of sync, needing a realignment and a bit of time tinkering with the monitor to set the picture straight again. Is this simply a voltage thing? Or could there be an issue with any of the components?
PCB problems and fixes
1 post • Page 1 of 1