Since I modified the connexions on my built in rapidfire button (pic#2), I'm wondering if I did smt wrong because when I plug/unplug the GND (pin#4 on rapid, going to posi.#2 on jamma) the image is moving... (1st pic is as is & 2nd pic is my personal configuration).
Instead of soldering rapidfires GND into its own place on jamma loom, I cutted it and pluged it to the already existing GND.
Per convenience, I did the same with push (pin#7 on rapid, going to posi.#22, #23, or #24 on jamma), like this I can change the rapid button depending the game I use instead of having a statitc push (#22)
For info: rapid header based on PCB is a JST PHR8.
p.s. Posi.#1/#2. are only for change speed (from 10/sec to 30/sec). Pls see button layout (pic#1)
http://www.higenekodo.jp/img/chouren2.pdf
Plugin' & unplugin' a GND...
-
erzane
- Not Made In Japan
- Posts: 824
- Joined: August 23rd, 2008, 12:52 pm
- Location: CH
- eBay: Gab79
Plugin' & unplugin' a GND...
You do not have the required permissions to view the files attached to this post.
Arcade's nice when done well