Problems with AW and Taito X2 Mobo
Posted: July 3rd, 2017, 10:41 am
Hi,
I have a few problems with two of my mobos and I hope that someone could give me some advise.
1. Taito X2
I do not get a picture.
I had this mobo in my Vewlix in the past and it worked fine. Then I sold the Vewlix and wanted to use the X2 again on my monitor with a supergun and an i/o board (have the Sega Rev. B and a Capcom one), but I don't get a picture out of it.
The PSU, fans etc. work. If I put the USB dongle in the port the LED lights up. Also if I use the DVI port and use a HD Fury 2 to VGA, the HD Fury lights up, so I guess it get a signal.
I only hear a beep sound and that is all.
Regarding DIP switches, I tried both (2 and 4) switchend them on and off, but no change.
Also I plugged the RAM module, graphic card in/out, but also no change.
Is there anything else, which I can try?
2. Atomiswave
This works absolutely fine in 31khz mode, but 15khz to the Jamma connector only, I can get only get a very dark picture, like missing colors etc.
This is the same via the supergun or in my cabs (Aero/Impress).
Any ideas?
Thanks in advance
I have a few problems with two of my mobos and I hope that someone could give me some advise.
1. Taito X2
I do not get a picture.
I had this mobo in my Vewlix in the past and it worked fine. Then I sold the Vewlix and wanted to use the X2 again on my monitor with a supergun and an i/o board (have the Sega Rev. B and a Capcom one), but I don't get a picture out of it.
The PSU, fans etc. work. If I put the USB dongle in the port the LED lights up. Also if I use the DVI port and use a HD Fury 2 to VGA, the HD Fury lights up, so I guess it get a signal.
I only hear a beep sound and that is all.
Regarding DIP switches, I tried both (2 and 4) switchend them on and off, but no change.
Also I plugged the RAM module, graphic card in/out, but also no change.
Is there anything else, which I can try?
2. Atomiswave
This works absolutely fine in 31khz mode, but 15khz to the Jamma connector only, I can get only get a very dark picture, like missing colors etc.
This is the same via the supergun or in my cabs (Aero/Impress).
Any ideas?
Thanks in advance