Hi
I have a time crisis pcb and I'm wondering if the powersupply below will be good enough to power the board and guns
Any info or help is appreciated
http://www.ebay.co.uk/itm/24V-Arcade-Po ... 1338787158
Time Crisis
-
- Posts: 598
- Joined: August 17th, 2008, 6:51 pm
- Location: Dublin, Ireland
- grantspain
- Tech Head
- Posts: 4824
- Joined: August 17th, 2008, 4:23 pm
- Location: down south
Re: Time Crisis
it won't run the game board,amps far too low on +5
-
- Posts: 598
- Joined: August 17th, 2008, 6:51 pm
- Location: Dublin, Ireland
Re: Time Crisis
Ok cool will it do the gun board 24volt could I use that and a normal switcher?
- grantspain
- Tech Head
- Posts: 4824
- Joined: August 17th, 2008, 4:23 pm
- Location: down south
Re: Time Crisis
yes that would work,tc cabs used a transformer/bridge and cap for the gun recoil
-
- Posts: 598
- Joined: August 17th, 2008, 6:51 pm
- Location: Dublin, Ireland
Re: Time Crisis
Yeah I have a full game board but trying to fit it all on a smaller board.
So If I use the 24 v for powering the guns it will work, do I need to do anything like link grounds to the board power supply?
Thanks for the reply grant
So If I use the 24 v for powering the guns it will work, do I need to do anything like link grounds to the board power supply?
Thanks for the reply grant
- grantspain
- Tech Head
- Posts: 4824
- Joined: August 17th, 2008, 4:23 pm
- Location: down south
Re: Time Crisis
not sure if the 24v supply need a 5v load to run,find out when you connect it