Time Crisis

PCB problems and fixes
Post Reply
purplec
Posts: 601
Joined: August 17th, 2008, 6:51 pm
Location: Dublin, Ireland

Time Crisis

Post by purplec »

Hi

I have a time crisis pcb and I'm wondering if the powersupply below will be good enough to power the board and guns


Any info or help is appreciated

http://www.ebay.co.uk/itm/24V-Arcade-Po ... 1338787158
User avatar
grantspain
Tech Head
Posts: 4523
Joined: August 17th, 2008, 4:23 pm
Location: down south

Re: Time Crisis

Post by grantspain »

it won't run the game board,amps far too low on +5
purplec
Posts: 601
Joined: August 17th, 2008, 6:51 pm
Location: Dublin, Ireland

Re: Time Crisis

Post by purplec »

Ok cool will it do the gun board 24volt could I use that and a normal switcher?
User avatar
grantspain
Tech Head
Posts: 4523
Joined: August 17th, 2008, 4:23 pm
Location: down south

Re: Time Crisis

Post by grantspain »

yes that would work,tc cabs used a transformer/bridge and cap for the gun recoil
purplec
Posts: 601
Joined: August 17th, 2008, 6:51 pm
Location: Dublin, Ireland

Re: Time Crisis

Post by purplec »

Yeah I have a full game board but trying to fit it all on a smaller board.

So If I use the 24 v for powering the guns it will work, do I need to do anything like link grounds to the board power supply?

Thanks for the reply grant
User avatar
grantspain
Tech Head
Posts: 4523
Joined: August 17th, 2008, 4:23 pm
Location: down south

Re: Time Crisis

Post by grantspain »

not sure if the 24v supply need a 5v load to run,find out when you connect it
Post Reply