Converting a Pana twin/pana custom to 240V and PAL

[penrhos]

Usual disclaimers apply (ie dont mess around with mains voltages if you dont know what your doing and its not my fault if you blow yourself/kit up)

Converting a Pana twin/pana custom to 240V and PAL

Its realy simple to convert any of the PANA Superguns to 240V and PAL.

1) Disconnect from mains and allow to sit overnight to allow the PSU's capacitors to discharge.

2) remove the screws that hold the top onto the base and lift the lid off.

3) locate the PSU and the sticker that says 110/220V - there is a simple sliding switch by is and it can be moved by poking a screwdriver through the holes in the PSU cage.

4) change the sliding switch to the 220V position - make sure it slides all the way across - if unsure slide it back to 110V and back again making sure it wont go any further.

5) if you want to switch to PAL there are two small switches on the video board, if you look carefully you will see they are labeled PAL/NTSC - move both to the desired TV format.

6) re-assemble.

7) Optional - cut off 2-pin plug and replace with UK 3-pin or use one of those US/JPN 2-pin to UK 3-pin adapters.

8) Test and adjust 5V - using the 5V adjust pot on the back if required.