Nanao MS9 Yoke Connectors

[cools]

Anyone have any idea what the parts here are?

Ignoring the pin number markings, one is clearly marked AMP and 44, the other is marked SMK and C. So I know the brands, but it's like searching for a needle in a haystack for the parts!

[Devil Soundwave]

Anyone have any idea what the parts here are?

Ignoring the pin number markings, one is clearly marked AMP and 44, the other is marked SMK and C. So I know the brands, but it's like searching for a needle in a haystack for the parts!

Give me pics and the number of pins to work from and I'll try and find you something to suit.

Do you know the pitch? If not, hold the inch side of a ruler next to it when you take the pics.

[cools]

They're both 2 pin, and massive pitch. Unfortunately I don't have photos of them that are worth a jot, because the poxy things nuked themselves when disconnecting Should be the same on an MS8 too - if anyone could get pictures that'd be great!

[yosai]

I've got an MS9 chassis loose here. I'll take a bunch of pics tomorrow morning.

[cools]

Haha, yeah I suppose that'd make more sense, find something that'd fit the chassis yoke plugs

[yosai]

Remembered I put it up in the loft last week. I'll grab it down tomorrow morning and take some pics if they're still required.

[Devil Soundwave]

Yes please Lee.

[cools]

If I remember I'll take some tonight too

[Devil Soundwave]

I'll take some pics tonight too. I don't have an MS9 though, so they'll just have to be pictures of me looking awesome.

[cools]

How are these?

http://www.flickr.com/photos/rogalian/s ... 411414850/"

[Devil Soundwave]

Picturesque!

Gonna be tough. I'll get right on it.

[cools]

Excellent. Think I'm getting the hang of the camera on this phone

[yosai]

Good job. I don't have to go in the loft now.

[cools]

Anyone have any idea at all of where I should look?

[yosai]

Easiest place would be to get them from a buggered tube. You just need one set? I'm sure someone must have one.

[Devil Soundwave]

These do?

[cools]

I will check in a bit

[cools]

Measures up fine!

[Devil Soundwave]

You can haz them then sir. Need addrezz.

BTW - these came from a Naomi Yoke. Once you have them, if they definately fit, we should document that.

Manufacturer = CWB Electronics

"TJC2 Pressure Welding Bar Connector" is the small white one.

Part nos:

TJC2-2Y = Female connector, 2 positions
TJC2 = Pins

http://www.cwb.com.cn/en/proView.asp?id ... 16&iid=301"

"TJC1 Pressure Welding Bar Connector" is the large grey one.

Part nos:

TJC1-2Y = Female connector, 2 positions
TJC1 = Pins

http://www.cwb.com.cn/en/proView.asp?id ... 16&iid=305"

CWB have a German office and a US office (thankfully!) so we can probably ask them where we can buy the parts new...

[cools]

Roger