Hey all,
So I've been putting off pulling the cab apart for try and fix my convergence issues but I finally had a go.... With semi-success.
I had:
Top left: Red bend (minor)
Bottom left: Blue bend (minor)
Bottom Right: Red and Blue bend (medium)
All the above were fixed in under 5 mins with convergence strips (yay). But the top right.... UUUGH the red is bending and the yellow and blow are vertically out.. After quite a bit of time with strips I've gone from this...
To this....
MUCH better on red but I cant see to get the other colours in line. Basically, if I align them red is worse than ever and I've run out of room for jamming convergence strips down the back of the yoke. So, anyone got any tips? do I need to make strips with much srtonger magnets? do I need to go from first principals and reseat the yoke (hesitant to do this as it;s ONLY the top right that's out. the rest of it is actually really good after tweaking).
Basically... Any suggestions?
Fixing MS-2930 Convergence (Almost done, any ideas?)
- LegoYoda
- Posts: 139
- Joined: December 21st, 2012, 1:27 pm
- Location: South East UK
- eBay: neomonster
- Initials: AGD
Fixing MS-2930 Convergence (Almost done, any ideas?)
You do not have the required permissions to view the files attached to this post.
Alec
----------------------------------------
Owning a Blast City: Fixing and Repairing -http://retrogamingstuff.wordpress.com/
----------------------------------------
Owning a Blast City: Fixing and Repairing -http://retrogamingstuff.wordpress.com/