Hey folks me again
I have a ms2930 that does not have any blue. Blue gun work, for sure. If I turn up the blue cut off the whole screen will turn blue. If I swap the red and blue wire going to neck board blue will show in the red location. If I swap the red blue from pcb to chassis I get nothing. From that I take it I have a problem somewhere in the main chassis. Adjusting the blue bias on the control board does not change much on the blue output of the M51387P IC. With red I can see it fluctuate.
Another ms2930 problem
-
- Please Continue...
- Posts: 19
- Joined: June 20th, 2016, 6:18 pm
- Location: Canada BC
- eBay: Blood_pack
- Initials: HVD
- grantspain
- Tech Head
- Posts: 4824
- Joined: August 17th, 2008, 4:23 pm
- Location: down south
Re: Another ms2930 problem
if you swap the red and blue wires to the neck card it will prove if the fault is neck card or colour decoder circuit
- nem
- Needs a custom rank
- Posts: 2776
- Joined: August 17th, 2008, 6:59 pm
- Location: Finland
Re: Another ms2930 problem
You sure the pot for the blue gain is working OK? Have you tried a different control board?XeD wrote:Adjusting the blue bias on the control board does not change much on the blue output of the M51387P IC. With red I can see it fluctuate.