Anyone using soft15khz to run an arcade monitor?
I have used it previously and when i chose a very low resolution it switched to 15khz mode so when it was on a pc minitor the screen was garbled, and when i plugged it into a 15khz arcade monitor it was great.
i hve just put another mame system together but this time its not working right - i have installed soft15khz, and run it to get 15khz mode going. i then used 'quickres' to change the resolution, and although i am able to choose very low res (300x200 for example), it doesnt seem to be switching into 15khz mode - my pc monitor displays the picture fine.
i am unable to try with the arcade monitor at the moment because i dont yet have my jPac, so anyone got any ideas?
soft15khz problem - advice needed
- chubsta
- I'm getting too old for this shit...
- Posts: 808
- Joined: August 17th, 2008, 5:13 pm
- Location: Folkestone, Kent, UK
- eBay: chubsta
- cools
- Armed Police Buttrider
- Posts: 13457
- Joined: August 17th, 2008, 4:49 pm
- Location: Wales, United Kingdom
- eBay: hordarian
- Initials: CLS
Re: soft15khz problem - advice needed
I've seen similar with a Radeon card in the past. It says it's switching, it's definitely in the right mode, but it's outputting a VGA type signal.
Very weird. This was on a laptop though.
Very weird. This was on a laptop though.
- chubsta
- I'm getting too old for this shit...
- Posts: 808
- Joined: August 17th, 2008, 5:13 pm
- Location: Folkestone, Kent, UK
- eBay: chubsta
Re: soft15khz problem - advice needed
heh - im a dumbass. rebooted and it went into 15khz mode
took ame a while to get a picture back, uninstalled soft15khz and all is well.
guess i need to do the switch as the very last thing befor i connect it to the cab...
solved anyway...
took ame a while to get a picture back, uninstalled soft15khz and all is well.
guess i need to do the switch as the very last thing befor i connect it to the cab...
solved anyway...
- joeblade
- You're looking good Tim
- Posts: 798
- Joined: September 13th, 2008, 6:18 pm
- Location: London
Re: soft15khz problem - advice needed
I got into trouble with this last week as it happens m8....chubsta wrote:heh - im a dumbass. rebooted and it went into 15khz mode
took ame a while to get a picture back, uninstalled soft15khz and all is well.
guess i need to do the switch as the very last thing befor i connect it to the cab...
solved anyway...
Took my sff pc out of my blast & hooked it up to my projector forgetting it was running soft 15k...
Couldn't be asked to put it back into the cab so i uninstalled my ati drivers, then re-installed them again!!
Doh!!!!
For gods sake, its a carton box - not the holy grail!